Did your PS3 beep three times when you tried to turn it on? Are you looking for the right solution for PS3 3 beeps of death that not only helps you fix the problem but also allows you to prevent it from happening again? Booting up your console only to hear the dreaded 3 beeps can be very infuriating, sad, and frustrating. Here are some things you can do to fix PS3 3 beeps of death.

1. Use the reflow process

What this basically means is that it tries to put the broken parts or contacts back together. You can do this by using a hair dryer directed at the processor plate. Run this on the board for 15-25 minutes. This will help the solder get hot enough to make contact with all the wires and cables.

2. Air dry the board

Then take it to a fan or air conditioner and allow it to blow on the processor for another 15 to 225 minutes. This is to allow the slightly melted solder to solidify and hopefully make contact with the wires again. After this, dock your console and boot it up to see if it turns on. If it’s still beeping, then it’s time to use the following PS3 3 Beeps of Death fix.

3. Get an instructional guide

There are guides that will help ease the process and explain the process in detail. By following the step-by-step videos in these guides, you’ll be able to troubleshoot, recover your saves – you’ll lose them if you send them to Sony and repair shops – and get your console up and running in 1-2 hours.

Related Post

Leave a Reply

Your email address will not be published. Required fields are marked *